1 Take off two components of a drinking straw, each piece 1 " long. Glue such an example pieces straight into the center of each V-shaped hole. The straw should sit perpendicular to open side, sticking in and as is also.
2 Cut two opposite sides away a large-sized plastic container finding a knife. The container must be at a minimum 1 feet high and One to three feet wide on them. Leave 6 inches at the end for that reason the water doesn't been used up . Involved with the now open sides, cut as little V-shape about One inch wide and 1 inch deep.
2 Cut two opposite sides away a large-sized plastic container finding a knife. The container must be at a minimum 1 feet high and One to three feet wide on them. Leave 6 inches at the end for that reason the water doesn't been used up . Involved with the now open sides, cut as little V-shape about One inch wide and 1 inch deep.
3 Cut a circular disk away from center of a typical plastic plate. The circular disk really should be flat and measure about Four to five inches across. bag making machine cut circular-shaped holes around the fringe of the disk, 1/2 an inch from edge . Trace around a soda bottle cap by using a pen to draw the circles, then cut them out with a knife or perhaps two of scissors. Use any grit-size emery paper to smooth the perimeters on the circles. Poke one small hole into your center using the the disk, simply using a nail.
4 Cut of one's hook and neck of an coat hanger, then unbend the triangle a section of the hanger to have a perfectly straight wire. The wire need to be balanced in between your open sides inside the container, using the disk hovering at the center, however it is not touching the base of the container. If for example your plate is loose all around wire in conjunction with the center hole, add silly puddy on each party therefore the disk will spin where the wire spins.
5 Material stick originating from a child's plastic pinwheel and attach silly puddy to your middle, with a back side of your respective pinwheel. It's possible to glue the silly puddy to be sure the pinwheel doesn't go away. Attach the pinwheel, facing out, to at least one end about the coat hanger, adding more silly puddy around the perimeter of wire when necessary.
6 Pour 5 tbsp. Of liquid dish soap within the bottom for this plastic container, then fill with water to it's lowest edges. Stir this type of water to thoroughly disperse the soap.
Dongguan Shunxiang Plastic machinery Co.Ltd.
------------------------------------------------------------------------------------------------------
Mobile:+86-13712930185 Whatsapp: +86-13712930185
Mobile:+86-13712930185 Whatsapp: +86-13712930185
Tel：+86-769-82226632 Fax: +86-769-82226632
Q Q：2953036079 Wechat:samshen05
Website: http://www.plasticrecyclingmachine.cc
Email:sam@shunxiangmachine.com fabor@shunxiangmachine.com
Address: No. 1, Xinyuan 5 street, Songbailang Village, Dalang Town, Dongguan City, Guangdong Province
-----------------------------------------------------------------------------------------------------
Main products of Shunxiang Plastic Machinery:
plastic recycling machine | blown film machine
--------------------------------------------
--------------------------------------------
